TD6M - the Lambda Series Little Brother

[Sebastian]

Simon, thanks again for your replay. I am thinking of a two way in non-mtm configuration -I do not like MTM dispersion characteristics (or something else associated with it), I have always preferred the single mid-woofer solutions. I am aiming at a highish sensitivity speaker excellent mids and highs, without very high SPL output. Maybe the Av10 would help minimize space. do you think the TM6 and the small Raal tweeter are a good match (crossed at around 2.8k)?

If you have experience with Av10 or AV12 setups I would be eager to read you comments an them (sealed, ported, bass quality,etc). The room I'll be placing them is around 20 m2.

Sebastian

[salvador]

I'm also planning to build in the future a 3.5 way using what you are, with a RAAL 140-15D, one TD6M and two TD10's.
By having two I could probably select the TD10H and go lower in frequency. Since you don't want a huge speaker this
could also be an alternative for you.

[simon5]

Maybe the Av10 would help minimize space. do you think the TM6 and the small Raal tweeter are a good match (crossed at around 2.8k)?

Should be fine, yes.

As for AV10 and AV12, they are excellent subwoofer drivers, and the alignment you choose depends on what sound you want, they will be good whatever you choose.

[xluorp]

Is the Dipole6 available yet? I see it mentioned on AE home page.

[stryke]

Yes, the Dipole6 are available. We have a few pieces currently in stock and ready to ship.

John

[xluorp]

What are the specs on the Dipole6 ? I've seen a price mentioned of $150. In this correct?
Thanks, Mike

[simon5]

$189 regular price and $150 preorder, I don't know which price is in effect right now.

[stryke]

Here are the Dipole6 parameters. They were optimized to be used along with the dipole12's or Dipole15's and cover a range ideally from 150-300hz to 3KHz or so.

Fs: 79hz
Qms: 11.7
Vas: 10.3L
Cms: .45mm/N
Mms: 9g
Rms: .38
Xmax: 3mm(one way)
Xmech: 8mm
Sd: 127sqcm
Qes: .78
Re: 6ohm
Le: .086mH
Z: 8ohm
Bl: 5.9Tm
Pe: 50w
Qts: .72
1WSPL: 90.2dB
2.83V: 91.4dB

John

[T3mpest]

What about these drivers big brothers lol the td8's? I'm currently running BMS 8N515's in my kicks, but I like your AV subs so much I wouldnt' mind at least trying your mids for comparison sakes.

[simon5]

If I check what John said about TD8 last time, they should be ready soon, maybe a month away.